I asked some of my colleagues what the approximate rate was for removing the water build up when opening a pool. This would be done prior to opening your pool. Also remember the water will be directed to the other end so don’t point it towards your home. Note: this may not get all of the water off. The idea is that this will create suction that will start draining the water from your pool cover. Then, turn off the water and move quickly! Act fast and disconnect the hose from the end of the faucet. Turn on the water from the spigot and let it run approximately one minute. Take the other end of the hose and connect it to the faucet. Your hose will be slightly squished and makes for slower draining. You’ll want to secure it on the edge of the swimming pool with the aforementioned brick. Take one end of the garden hose into the standing water. Make sure you have a hose that is long enough to reach both the spigot and the edge of the swimming pool cover. This can be accomplished by grabbing your standard garden hose, a brick and your spigot. This sounds like a risk I wouldn’t want to take! Garden Hose Siphon A word of caution: make sure your pool cover can withstand both the weight of the vacuum and the weight of yourself. So you may find yourself having to stop and empty it multiple times. When using a shop vac, you will find that they also get full pretty quickly. You will be required to climb and balance with an awkward piece of equipment. You can attempt to use a shop vac to rid the excess water from atop of your cover. There are some alternatives to a cover pump, but they require more energy and often money. I do not advise allowing water to accumulate on your swimming pool cover. No bueno! Stagnant water is also a breeding ground for mosquitoes and even algae. It is actually a drowning risk for small children and animals that could gain access to the top of your pool. The weight of the water by itself could tear, rip or sag your swimming pool cover. Why is water accumulation a bad idea? The accumulation of standing water can actually be dangerous on your swimming pool cover. If you do decide to forgo the cover pump, there are a couple of less efficient ways to remove the water. Do you have to have a cover pump? Not necessarily, but they do make life easier. This can cause all sorts of issues if not tended to throughout the Winter season. The issue with a swimming pool cover as it sits through the perilous weather, it starts to accumulate water build up. The leaves can also cause staining on the bottom of your swimming pool which can be difficult to remove come Summer. You actually CAN get algae in the Winter, contrary to common myths. The leaves and other organic loads become what is known as phosphates. If we don’t cover our pool and such debris sits in the water, it can actually wreak havoc. This prevents dirt and debris from getting in the water. □ 【Good Customer Service】 - If you have any questions or need technical assistance, please feel free to contact us, we will try our best to improve your experience.When we Winterize our Pools, one of the crucial steps is to cover the swimming pool.Put the pump in a barrier bag to prevent clogging when the surroundings are dirty. ✅【Must have accessories】Includes 1/2 inch (about 1.3 cm) hose adapter and 16 feet (about 4.9 m) hose for compact storage, saving the time and money of buying your own.✅【Safety Design】Built-in temperature control device can prevent the motor from drying out when the water is insufficient, and protect the water pump from damage.The socket is compatible with any standard 3/4" garden hose. ✅【Heavy Duty Shell】Heavy weighted wide base can attract water to the pump and prevent tipping.Simple to use - just place it and it will work.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |